Specifications For The Use Of Plastic Low-voltage Cable Waterproof Connectors

I don't know if you know much about Nylon Cable Gland. In our lives, it is widely used, but if the operator does not use it in a standardized manner, unexpected dangers may occur. Let's take a look at its usage specifications.

Plastic low-voltage cable waterproof joint usage specifications

When we use plastic low-voltage cable waterproof joints, we should pay attention to:

1. The cable joint should have good insulation and be firm and reliable, so that the cable can maintain the proper insulation strength.

2. The tension of the plastic low-voltage cable waterproof joint cannot exceed the load.

3. Under the premise of meeting the requirements, try to install it beautifully.

Operation process specifications for plastic low-voltage cable waterproof joints

1. The selected cable joint size specifications should correspond to the cable diameter and material.

2. Before installation, you need to use a clean cloth to clean the stains on the cable.

3. Saw off the faulty cable part, peel off a part of the protective cover at both ends of the cable, remove the steel armor, and expose the cable core.

4. The docking stages between each section of cable should be staggered and docked according to the original phase sequence. When connecting the conductors, ensure that there is no contact problem.

5. When using plastic low-voltage cable waterproof connectors for crimping, the corresponding cable die should be used. Generally, there are no less than 4 pressure pits when connecting with the connecting pipe.

6. After crimping, theater treatment is required. The specific treatment method is: wrap the exposed conductor with insulating tape. When wrapping, there should be no gaps between the insulating tapes.