Eight Points Of Knowledge About Nylon Cable Connector Manufacturers

1. What are the types of commonly used wires and cables according to their uses? According to their uses, they can be divided into bare wires, insulated wires, heat-resistant wires, shielded wires, power cables, control cables, communication cables, radio frequency cables, etc.
2. What types of insulated wires are there?
Common insulated wires include: polyvinyl chloride insulated wires, polyvinyl chloride insulated soft wires, nitrile polyvinyl chloride mixture insulated soft wires, rubber insulated wires, agricultural underground direct buried aluminum core plastic insulated wires, rubber insulated cotton yarn textile soft wires, polyvinyl chloride insulated nylon sheathed wires, polyvinyl chloride insulated soft wires for power and lighting, etc.
3. What occasions are nylon cable joint manufacturers suitable for?
Nylon Cable Gland manufacturers are suitable for indoor and outdoor overhead laying of power cables and control cables in general industrial and mining enterprises, and can also be used for indoor and outdoor installations in telecommunications, radio and television and other departments.
4. What are the cable accessories?
Commonly used electrical accessories include cable terminal junction boxes, cable intermediate junction boxes, connecting pipes and terminal blocks, steel plate junction troughs, nylon cable joint manufacturers, etc.
5. What is a nylon cable joint manufacturer?
The device that connects the conductor, insulation shield and protective layer of the cable to connect the cable line is called a nylon cable joint manufacturer.
6. What is the main electrical connection?
The main electrical connection is the connection method between the main electrical equipment and the busbar in the power plant and substation, including the connection method between the main busbar and the power supply system of the plant according to certain functional requirements.
7. What regulations should be followed when selecting the cross-section of power cables?
(1) The rated voltage of the cable should be greater than or equal to the rated voltage of the power supply system at the installation point;
(2) The continuous allowable current of the cable should be equal to or greater than the maximum continuous current of the power supply load;
(3) The cross-section of the wire core should meet the stability requirements of the power supply system during short circuit;
(4) Check whether the voltage drop meets the requirements based on the cable length;
(5) The small short-circuit current at the end of the line should enable the protection device to operate reliably.
8. What are the advantages of cross-linked polyethylene cable and oil-paper cable?
(1) Easy to install, because it allows a small bending radius and is light in weight;
(2) Not affected by line drop;
(3) Good thermal performance, allowing high operating temperature and large transmission capacity;
(4) Simple cable accessories, all of which are dry-type structures;
(5) Simple operation and maintenance, no oil leakage problems;
(6) Low price;
(7) High reliability and low failure rate;
(8) Few manufacturing processes, simple process, and significant economic benefits.